Turbine Products
Actuators
| Product | Application | |
 |
StG 2080 Actuator ATEX Certified HEINZMANN StG 2080 Actuators are rotary and direct acting all electric actuators with respectively 6.5 and 11 Nm torque output and either 36° or 68° rotation. Their distinctive features are a compact design and a high dynamic performance. They are used for diesel and gas engines as well as for dual fuel engines. They are driven by HEINZMANN analogue or digital controls units and HEINZMANN positioner units. HEINZMANN StG 2080 Actuators can be integrated with different throttle valve sizes for hot and cold gas engine applications. Additional integration of driver electronics turn these actuator models into positioning units suitable for current / voltage and PWM input signals. |
|
 |
StG 2120 Actuator Flameproof HEINZMANN StG 2120 Actuators are rotary and direct acting all electric actuator with a 13 Nm torque output and a 68° rotation. They have been designed for turbine applications and meet specific environmental requirements on top of their compact design and high dynamic performance. They work with HEINZMANN digital controls units and Heinzmann positioner units. |
All turbine applications |
 |
StG 30-90° Actuator StG 30.90 is a rotary actuator with disk armature motor combined with a gearbox. An explosion-proof type is available. It offers high regulation power working in both directions. Max. torque 28 Nm, holding torque14 Nm, rotation angle 0 - 90°. Extremely low current consumption during steady state. |
|
|
StG L500-50mm Actuator Flameproof Electric Actuator StG L500-50mm This is a linear actuator with built in electronic position control. It positions according to an external 4-20mA demand signal. Thrust is +/-5000 kNewtons and span is adjustable up to 100mm. Only 24VDC electric supplies are required to operate. |
Applications include steam governor valve or anti-surge valve control and guide vane control. |
 |
StG R500-90° Actuator Flameproof Electric StG R500-90° This is a powerful rotary actuator with built in electronic position control. It positions according to an external 4- 20mA demand signal. Torque is 100 Newton-metres and span is adjustable up to 90 degrees. Only 24VDC electric supplies are required to operate. |
Applications include large gas fuel throttle or bleed valve controls for gas turbines. |
